13384 Simple Green Dispenser, Bottle, Bucket, 1 gpm

Simple Green 4 + 1 Select Proportioner provides accurate and easy product dilution, ensuring concentrated cleaning products are consistently mixed to peak performance. This American Society of Safety Engineers (ASSE) 1055 approved multi-product proportioner includes 4 low flow (1 GPM) bottle fill and 1 high flow (3.5 GPM) bucket fill outputs with the capability to dispense up to 5 chemicals or water at 5 separate dilution ratios. The easy-to-use unit features AccuPro Pressure Regulation Technology to ensure accurate dilution regardless of fluctuations in water pressure. E-Gap eductors provide backflow protection through the use of elastomeric sleeves. The proportioner includes 14 pre-set metering tips that provide 1:2.6-1:447 dilution ratios, one customizable tip for non-standard dilutions or water dispensing, a 4 foot bucket fill hose with convenient storage hook, the option to lock in the on position and an expansive internal workspace for plumbing and pick up tubing.

KEY FEATURES

• Dispenses 1 Simple Green concentrate at 4 different dilutions
• Accommodates up to 4 different dilutions
• Delivers diluted solutions at 1 GPM
• Includes metering tip kit
• Includes bottle-fill nozzle and 6-foot bucket-fill hose
• Accommodates up to 5 separate dilutions

Usage

1.Place foot valve ends of supply tubes into concentrate containers. REMEMBER TO CHECK FOOT VALVE STRAINERS REGULARLY FOR CLOGGING: CLEAN IF NECESSARY.\r\n2. A short discharge tube is used with the 1GPM eductor; minimum tube length is 8 inches (20cm) for proper operation. Longer tubes (4 feet) are used with a 3.5 GPM eductor. Do not remove the flooding rings from inside the tubes. Slide end of tube with flooding ring over eductor discharge outlet. (Repeat for all eductors.) Hooks may be installed on longer tubes to allow discharge tube to conveniently hang from dispenser when not in use.\r\n3. Replace cabinet cover. Push the sides in, behind the latch holes, to snap the cover in place. The two screws provided may be installed in the holes in the cabinet sides to prevent easy removal of cover.\r\n4. Connect water supply hose of at least 3/8 " ID to water inlet swivel. (Minimum 25 PSI pressure, with water running, is required for proper operation.) Connect opposite end of hose to water supply. Turn water supply on.\r\n5. Purge air from the system by depressing the buttons briefly. There may be some water discharge from the eductor vents until the air is purged.\r\n6. Push button to start flow of desired water/concentrate solution, and hold until supply tube is primed (filled).\r\nThen push the button whenever dispensing is desired, and release button to stop flow of solution. If you wish to be able to lock the button in the "on" position: Depress button and slide button lock up. To unlock, depress button and release.\r\n7. It is essential that the discharge hose not be obstructed. If discharge is restricted, water will flow out the educator vents. Do not start to operate the dispenser with liquid in the discharge tube.

Applications

Custom dilutes one concentrated Simple Green cleaner to 4 different strength dilutions